-This 3′ jumper can be used to extend the distance between two shelves or from the controller to a shelf.
-Each shelf already includes a 20″ jumper.
This cable would be used if 20″ is not long enough or to connect to the 20″ jumper to extend it to nearly 5′.
**The actual length of this cable is 40″
Frequently Asked Questions
-Do I need to purchase this jumper?
No. Each shelf already comes with this jumper. This would only be needed to extend a jumper over 3′.
-Can I connect more than 2 cables together?
Yes. You can connect multiple jumper cables together or you can purchase an 80″ jumper.
-Can I run this cable through my walls?
This cable only carries 12v low voltage power so in most cases it will be fine. However, you should always check your local electrical codes before running wiring through your walls.